![amino stb amino stb](https://s1.manualzz.com/store/data/002146426_1-50394b2e2ce1c85ff2fcf4c3cd4b1c38.png)
To configure a set-top box with this firmware from the USB keyboard connected to the set-top box, you must press Alt-M, then enter the password leaves and you will be taken to the settings menu, to confirm the changes the password is snake.
#Amino stb manual#
Please press Enter to activate this console.īy default, the login is root, the password is root2root, they are in the linux console.īy the way, the firmware for the console can be taken here in the form of an image of a VMware virtual machine, there is also a firmware manual there. If we did not interrupt the download and the console fully loaded it will give us a greeting: Press the Enter key, we get to IntActOS theįormat - clear NAND, the prefix will be ready to get new firmware for multicast. Before loading, the prefix will write:ĪmiNET Multicast BootROM, version 1.41.07įile: NAND Flash size detected as 32 MBytesĮthernet: STB7109 MAC at 0xB8110000 IRQ: 2Įthernet: MAC address 00: 02: 02: 29: C1: BE We supply power to the set-top box, run Minicom or Hyperterminal, with the settings 115200 bps, 8 bits, 1 stop bit, NO parity and NO flow control. I did not solder the connector in the prefix, I just inserted a cambric from the wire between it and the neighboring connector so that our connector became strut, having good contact with the board.
![amino stb amino stb](https://data2.manualslib.com/first-image/i42/206/20549/2054832/santel-amino-a140.jpg)
Half the cost was the circuit board.Īnd the STB amino diagnostic cable appeared, weĬonnect the cable to the COM port and set-top box. Pinout on the set-top box (the first pin is indicated by a square),Īfter which they were purchased at the store:įor everything 93 rubles were spent. A lengthy search was successful and a circuit diagram of a converter in RS-232 was found: But nowhere is said anything about what kind of cable it is, what kind of pinout it has. There it is reported that on each console there is a wiring for a 4-pin connector, through which you can connect a diagnostic cable.
![amino stb amino stb](https://www.meko.co.uk/images/2017/May/aminologo.png)
Having rummaged a bit on the Internet, I found Debug Cable - Quick Reference, which contains some useful information.
#Amino stb how to#
And the question arose before me how to bring it back to life. After an unsuccessful attempt to flash the amino 130m prefix, it turned into a vegetable and did not respond to attempts to reflash it.